Blowers for fuel cells

The blowers for fuel cells from ebm papst can be

  • with an air volume of 50 m³/h to 8,000 m³/h,
  • at a counter pressure of 40 Pa to 7,000 Pa,
  • with a size of 71 mm to 450 mm,
  • Conveying medium temperature max. 60 °C,
  • with a rated voltage of 100 V – 240 V (single-phase) or 380 V – 480 V (three-phase)
  • and at a frequency of 50/60Hz

be operated.

Please contact us for further technical information or special requirements!

Category:

Product informations

The basis of the blowers for fuel cells are ebm-papst centrifugal blowers for heating technology. These are used in gas condensing boilers, gas water heaters, gas boilers, gas and oil burners, fuel cells and other gas appliances with very low output or for high boiler outputs.

The ebm-papst blowers for heating technology achieve a modulation ratio of 1:10 thanks to the interface for speed output and speed control. They can be extended with a gas valve, automatic burner control unit, Venturi mixer and mass flow sensor for an optimally harmonised system.

Ideal for higher pressures in condensing boiler technology. For an optimised combustion process and low NOx emissions.

Voltage

100 – 480 V, 24 VDC

Frequency

50/60 Hz

Air flow rate

50 – 8.000m³/h

Power consumption

20 – 14.000 W

Counter pressure

40 – 7.000 Pa

EC technology

Various control and regulation functions

Enclosure

Aluminium, Cast aluminium

Fan impeller

Aluminium sheet, Metal, Plastic

Motor protection cap, motor protection sheathing

Cast aluminium, Metal, Plastic